Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

EIGRP routing

Please see the attach image.

Thanks a lot

Moses

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: EIGRP routing

Hello Moses,

on hub router you need to use PBR to route traffic with source 192.168.0.1 via ser1/1

You need also to increase interface delay on ser1/1 so that all other traffic is routed via s0/1.

This will make EIGRP to prefer path via s0/1.

int ser1/1

delay 60000

access-list 121 permit ip host 192.160.0.1 any

route-map pbr_divert permit 10

match ip address 121

set interface ser1/1

on lan interface(s)

int fa0/0

ip policy route-map pbr_divert

on the stub spoke router eigrp is enough to achieve the desired results combined with the host specific static route for the server

Hope to help

Giuseppe

1 REPLY
Hall of Fame Super Silver

Re: EIGRP routing

Hello Moses,

on hub router you need to use PBR to route traffic with source 192.168.0.1 via ser1/1

You need also to increase interface delay on ser1/1 so that all other traffic is routed via s0/1.

This will make EIGRP to prefer path via s0/1.

int ser1/1

delay 60000

access-list 121 permit ip host 192.160.0.1 any

route-map pbr_divert permit 10

match ip address 121

set interface ser1/1

on lan interface(s)

int fa0/0

ip policy route-map pbr_divert

on the stub spoke router eigrp is enough to achieve the desired results combined with the host specific static route for the server

Hope to help

Giuseppe

96
Views
0
Helpful
1
Replies
CreatePlease to create content