Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EIGRP standard routing question

Please look at the attached visio. My question is how does the router with network 10.0.0.0 know about 172.20.0.0 and 172.20.9.0 on the other side since i am only using 172.19.1.0 in EIGRP? the switch 172.19.1.8 knows how to get to those networks.

Thanks

6 REPLIES
Hall of Fame Super Blue

Re: EIGRP standard routing question

Could you send a jpg as well as not all of us have access to visio. Are the configs included in the visio.

Jon

Hall of Fame Super Bronze

Re: EIGRP standard routing question

Hard to tell without seeing the whole routing table on the device with network 10.0.0.0 configured.

If the default route on this device is pointing to a router that knows how to get to 172.20.0.0 and 172.20.29.0, then that's your answer.

Attaching the diagram as JPEG for the benefit to those without Visio.

HTH,

__

Edison.

New Member

Re: EIGRP standard routing question

The MPLS router containing the 10.0.0.0 hangs off a 3750 core, where i have a default route pointing to the MPLS router in Canada.

Hall of Fame Super Bronze

Re: EIGRP standard routing question

And if the MPLS Router in Canada knows about those subnets, then that's how the IP reachability is made.

You can also find out what router is being used for connectivity with a traceroute from the source router to the destination subnet.

In addition, if you want a conclusive answer, you need to provide more information - like full routing table from devices in question.

Hall of Fame Super Blue

Re: EIGRP standard routing question

Just to clarify. When you say knows about - do you mean can route to or do you mean has the subnets in the routing table.

Jon

New Member

Re: EIGRP standard routing question

I will add static routes on both MPLS routers. I was unsure if they needed to be added in the EIGRP AS, but since they don't lie within those subnets, I will add the statics.

Thanks

111
Views
0
Helpful
6
Replies