Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

EIGRP update being received on all but 1 router

Made an update to an access list (advertising a new subnet out all interfaces) and all but 1 router received the update. The configs look to be identical so not sure why this one router is not updating it's routing table. When you do "sh ip eigrp traffic" the router in question is getting updates, hellos, etc.. When I do "sh ip route x.x.x.x." the response back is "subnet not in table".

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: EIGRP update being received on all but 1 router

Hello Nancy,

try to restart that specific EIGRP adjacency if it is on a dedicated link by shutting down and then up the link on the core side

Hope to help

Giuseppe

5 REPLIES
Hall of Fame Super Silver

Re: EIGRP update being received on all but 1 router

Hello Nancy,

verify if that specific router has a distribute-list inbound filtering the new subnet (for example allowing only the old ones)

Hope to help

Giuseppe

New Member

Re: EIGRP update being received on all but 1 router

no such luck but thanks anyhow.

Hall of Fame Super Silver

Re: EIGRP update being received on all but 1 router

Hello Nancy,

try to restart that specific EIGRP adjacency if it is on a dedicated link by shutting down and then up the link on the core side

Hope to help

Giuseppe

New Member

Re: EIGRP update being received on all but 1 router

That's what I was planning on doing - and sure enough - that fixed it! Thanks.

Silver

Re: EIGRP update being received on all but 1 router

Is it possible to post the config of the eigrp and acl/route-maps on the advertising router. and one working end point router and the router not receiving the route?

121
Views
5
Helpful
5
Replies
CreatePlease to create content