Enable mls qos trust dscp in interface of router 2821
In L3 and routers these commands not used as in the router you just match, mark or remark ip tos header in L3 which is either the ip precedence or dscp value in other words you do not need to do trust on the router trust works on edge switches and uplink L2 trunks only
You can match the marked traffic coming to the router then apply the required traffic treatment to it such queueing, policing or remarking
You might need to mark the traffic in the incoming interface of the router and this can be done by using, ACL, class maps and policy maps see the bellow links for more details
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...