right now we have here at our headquarter two Cisco 1812 in place for DMVPN. one is active and the other one is cold stand by. due to replacement of 19" racks we shifted the service over to the cold stand by unit. the cisco servers 17 tunnel endpoints without any problem.
then i realized that i have two different ios versions on these cisco routers. the original working one runs "c181x-adventerprisek9-mz.124-15.T5.bin" and the cold stand by one runs "c181x-advipservicesk9-mz.124-15.T5.bin".
both units run just fine with exactly the same startup-config. i could not find any differences serving our tunnel endpoints.
is there some kind of feature-matrix available, which outlines the differences between these versions? thanks a lot.
thank you for the link. the document was quite helpfull and i got an small overview. but i'm still looking for some kind of matrix, which would show me in detail what parts are available in which versions.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...