Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ENTITY_ALARM-6-INFO

Getting the following error on Cisco 7206VXR w/ IOS c7200-adventerprisek9-mz.124-9.T7.bin

Sep 26 08:43:57: %ENTITY_ALARM-6-INFO: ASSERT MAJOR Se2/0 Receiver has remote alarm

Sep 26 08:43:58: %ENTITY_ALARM-6-INFO: CLEAR MAJOR Se2/0 Receiver has remote alarm

Any suggestions would be appreciated and I will provide any additional information as needed.

Added: The interface is flapping.

1 REPLY

Re: ENTITY_ALARM-6-INFO

Hi,

most likely this is because of circuit issue with carrier. Your circuit is flapping. If you run 'Sh int ser2/0' then you can oserve increasing 'Carrier transitions'. Call the carrier and ask them to resolve the circuit issue.

HTH

MS

873
Views
0
Helpful
1
Replies