Hello. The other day I decided to upgrade my old 10/2Mbps connection to a 100/5Mbps cable connection and my ISP gave me the EPC3825 router. When using an ethernet cable everything works great and my speedchecks max out every time, the problem is that I can't have cables all over my apartment so I'd like to use wireless. With a computer located right next to the router I've gotten as high as 20Mbps and usually I'm left at about 3Mbps. I'm aware that using wireless can result in a small drop of speed but this just seems too much, especially considering the fact that I ran a steady 10Mbps when using wireless on my old connection.
I have tried every solution I can think of in the router setup but if there's anything that might help I would appreciate it.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...