i have a 3600 series router in which i could not boot the system. it comes into rmon mode. im trying to put an ios image through xmodem but it showes me this message kindly advice me how to proceed with this upgradation, i have set the confreg to 0x2102:
boot: cannot load "flash:"
System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
C3600 processor with 65536 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
rommon 1 > boxmodem -c c?Rk???z????4Q7.bin
Do not start the sending program yet...
File size Checksum File name
14906116 bytes (0xe37304) 0x22c1 flash.bin
WARNING: All existing data in flash will be lost!
Invoke this application only for disaster recovery.
Do you wish to continue? y/n [n]: y
Ready to receive file c3640-jk9o3s-mz.123-14.T7.bin ...
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...