Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Error message.

I am using the 2600 router with the IOS 12.3(12a). The fastethernet 0/1, the line protocol and the port is up but it does not ping to the other end and it gives a error message at the regular interval "FastEthernet0/1 transmit error/max active/max total)" but when it is connected to Fa0/0 it works fine and the error message does not come.

can someone help me over this issue.

1 REPLY
Silver

Re: Error message.

Late collisions have occurred on the Ethernet or Fast Ethernet interface. When a collision

is detected by a station after it has sent the 512th bit of its frame, it is counted as a

late collision.

Recommended Action: If the interface is a Fast Ethernet interface, verify that both peers

are in the same duplex mode. For regular Ethernet, the system should recover. No action is

required.

Try this link:

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_tech_note09186a008009446d.shtml

107
Views
0
Helpful
1
Replies