Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Error - while boot router

Dear Team,


find the attachment, while load the router i get error.. please assist for the same

Best Wishes = Pradip Patole

1 REPLY
Hall of Fame Super Silver

Re: Error - while boot router

When the message describes a software forced crash it sounds like it might be a software problem in the image that you are running. And the checksum error as it attempts to load the image also suggests that there is a problem with the image that you are attempting to run. Based on these errors there is also some possibility that there might be a hardware problem that is impacting your flash.

Is this a router that has been running for a while and then this started? If so were any changes made recently? Or is this router a new install and this is your first attempt to use the router?

In any case your best option is to open a case with Cisco TAC about this problem.

HTH

Rick

157
Views
0
Helpful
1
Replies
CreatePlease to create content