Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

error while using compress config command

Hello,

I'm getting the following error in 3550 Layer-3 Switch while trying to save the configuration.

ASP3550L3-1#wr

Building configuration...

% Warning: Saving this config to nvram may corrupt any network management or sec

urity files stored at the end of nvram.

Continue? [no]:

I tried to use the service compress-config and it gives the following error.

ASP3550L3-2(config)#service compress-config

Boot ROMs do not support NVRAM compression.

Disabling service compress-config.

Below is the ver and model of the 3550 Switch.

ASP3550L3-2#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(19)EA1c, RELEASE SOFTWARE

(fc2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Tue 03-Feb-04 05:31 by yenanh

Image text-base: 0x00003000, data-base: 0x0080DFF0

ROM: Bootstrap program is C3550 boot loader

ASP3550L3-2 uptime is 19 weeks, 1 hour, 24 minutes

System returned to ROM by power-on

System image file is "flash:c3550-i5q3l2-mz.121-19.EA1c/c3550-i5q3l2-mz.121-19.E

A1c.bin"

cisco WS-C3550-48 (PowerPC) processor (revision L0) with 65526K/8192K bytes of m

emory.

Processor board ID CAT0809R0TM

Last reset from warm-reset

Bridging software.

Running Layer2/3 Switching Image

Ethernet-controller 1 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 2 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 3 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 4 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 5 has 1 Gigabit Ethernet/IEEE 802.3 interface

Ethernet-controller 6 has 1 Gigabit Ethernet/IEEE 802.3 interface

48 FastEthernet/IEEE 802.3 interface(s)

2 Gigabit Ethernet/IEEE 802.3 interface(s)

The password-recovery mechanism is enabled.

384K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address: 00:0F:34:D0:E7:00

Motherboard assembly number: 73-5701-09

Power supply part number: 34-0967-02

Motherboard serial number: CAT08090SW5

Power supply serial number: LIT072700RZ

Model revision number: L0

Motherboard revision number: A0

Model number: WS-C3550-48-EMI

System serial number: CAT0809R0TM

Configuration register is 0x10F

2 REPLIES

Re: error while using compress config command

Hi

Cisco 3550 doesnt support config compression,do find the link and follow the workaround provided.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bfab.shtml#cat3550

regds

New Member

Re: error while using compress config command

Thanks ed.

301
Views
0
Helpful
2
Replies
CreatePlease to create content