Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Errors running 1:8 pattern on VWIC-2MFT-T1 card

Issue discovered while stress testing two T1s. T1s test clean h-2-h when cable removed from VWIC-2MFT-T1 (T1 (2 port) Multi-Flex Trunk WAN daughter card), but can not run 1n8 test pattern to CSU loop. Tried this with two different cards with same result.

Does anyone know of any issues like this?

1 REPLY
Silver

Re: Errors running 1:8 pattern on VWIC-2MFT-T1 card

The 1:8 pattern is the borderline test pattern that invokes B8ZS. If you are getting errors on this pattern then you have a line code mismatch somewhere on your line (Eq, CSU, Telco, DACs, etc..)

353
Views
0
Helpful
1
Replies