Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Establish reverse telnet using aux port

Hi,

I am trying to establish a reverse telnet session from the aux port of 3845 router to another 6500 switch.

Please suggest how I can do this,configuration assitance will be appreciated.

thanks

gagan

2 REPLIES

Re: Establish reverse telnet using aux port

New Member

Re: Establish reverse telnet using aux port

Hello,

I make back-to-back connexion from AUX port of 2600 series Router to any Cisco Console port using an old cisco blue or black RJ45 to RJ45 console cable (it is a cross cable , wire 1 connect to wire 8, 2 to 7, 3 to 6, 4 to 5, ...)

on the 2600 router i have :

router#sh run | b aux

line aux 0

session-timeout 5 output

location TO 6500 switch

no motd-banner

no exec-banner

exec-timeout 5 15

terminal-type vt100

no exec

no history

no editing

transport input all

transport output all

stopbits 1

router#sh line

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int

0 CTY - - - - - 0 0 0/0 -

65 AUX 9600/9600 - - 91 - - 13 8 0/0 -

Now you just have to make a telnet to the router IP address using port number 2065 (AUX port is number 65)

telnet 10.0.0.118 2065

454
Views
0
Helpful
2
Replies