I know it is possible to configure Etherchannel on a Cisco switch. A customer is asking if this can be done on a Cisco router (combining 2 ethernet interfaces into 1) for redundancy in case 1 interface go down. Can anyone confirm whether this can be done? Thanks.
IMO, yes, otherwise, it is too costly to use router port for only increase the bandwidth but the WAN side is low bandwidth only. Normally, I could suggest to use L3 switch instead of router to enable Etherchannel.
Q. Do the LAN interfaces on the platforms support aggregation through EtherChannel or PAGP technologies?
A. No, the onboard LAN interfaces do not support aggregation technologies. Aggregation can be achieved using one of the EtherSwitch network modules, or the EtherSwitch Service Module. No modules support aggregation in the Cisco 2801.
This means it is possible on a router with a Etherswitch module (a switch basically).
I'm working on a project that includes basic router configurations. I configurated everything including: line console 0, line vty 0 15 and secret passwords. There are 3 routers in the network and every LAN is going t...
Desire to create Terminal Server ("TS" in this document) out of 2811 Cisco Router with HWIC-16A card (with Octal cables)
Desire to use SSH over Telnet
TS is ip'ed, SSH access configured (to the TS)
Python based Script to BULK Import/Delete devices using Cisco Prime API
Check my Repo on GitHub for all the details ( see below link )