Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel 3750 questions

Hello,

I would like to deploy this kind of configuration (See attached network plan).

My questions are:

1) is possible to enable etherchannel links between different switches, without stacking links?

2) how is the expected bandwith consumption when I enable etherchannel PAgP or LACP protocol?

Thanks a lot,

3 REPLIES

Re: Etherchannel 3750 questions

Yes, you can run the links between the switches as EtherChannels. This is a particularly useful technique if you want the switches to be located further than a stacking link will allow.

As for PAgP and LACP, the bandwidth they use is absolutely negligible compared with the bandwidth of the underlying links. Effectively, if you EtherChannel two Gig links you have 2 Gbps to play with.

Kevin Dorrell

Luxembourg

New Member

Re: Etherchannel 3750 questions

Thanks Kevin for response,

but do you think that is possible to determine which is the traffic load on linking two switch by etherchannel?

I mean that I want use radios link between each port that partecipate to Etherchannel.

Re: Etherchannel 3750 questions

Hi Valerio,

I am assuming you are asking about load balancing across the link on the Etherchannel Since you are enquiring about this on a 3750 switch, please find below information in regards to this.

EtherChannel load balancing can use MAC addresses or IP addresses, source or destination addresses, or both source and destination addresses. The mode applies to all EtherChannels that are configured on the switch. You configure the load balancing and forwarding method with use of the port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac} global configuration command.

You can find out which interface is used in the EtherChannel to forward traffic based on the load balancing method. The command for this determination is test etherchannel load-balance interface port-channel number {ip | mac} [source_ip_add | source_mac_add] [dest_ip_add | dest_mac_add].


Also find the below link which talks abit more about load balancing on ethernchannel

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_25_se/configuration/guide/swethchl.html#wp1116754

HTH,

Regards,

Please rate if helpful

183
Views
0
Helpful
3
Replies
CreatePlease login to create content