Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ethernet interface redundancy

Hi,

Is it possible to use HSRP/VRRP internal one router if you want to have redundancy between two interfaces?

Our customer has router with two Ethernet interfaces.

This two interfaces are connected to two switches, there is also cross cable between the switches.

On the other side of the switches there are two other routers connected.

The customer will not use any routing protocols to get redundancy between the standalone router and the two separated routers.

Need some ideas how we can solved this.

//Niklas

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Ethernet interface redundancy

Hello Niklas,

you can use IRB integrated routing and bridging: HSRP will not work as well explained by Jon.

bridge 1 protocol ieee

bridge 1 route ip

bridge 1 bridge ip

int eth0

no ip addr

bridge-group 1

int eth1

no ip addr

bridge-group 1

int bv1

ip address x.x.x.x

! this the layer3 interface

be aware that STP will block one link but it will be ready to be used if the first fails

you can uses static routes with IP next hops the ip addresses of the VIP of the HSRP made on the other two routers (on them you can they are two different boxes)

the other two routers will have static routes to the BVI ip address as next hop

be aware that until a router has an ARP entry for the ip next hop and its own interface is up the static route is considered valid

Hope to help

Giuseppe

3 REPLIES
Hall of Fame Super Blue

Re: Ethernet interface redundancy

HSRP will not work because you cannot assign 2 IP addresses out of the same subnet on 2 ethernet interfaces on the same router.

What type of redundancy are you looking for. If you cannot use routing protocols you could look into floating statics but it's very difficult to be more precise without more details.

Jon

New Member

Re: Ethernet interface redundancy

yes.

I think the best solution is to use floating static route

for example:

x.x.x.x 255.255.255.0 Fe1

x.x.x.x 255.255.255.0 Fe2 10

Hall of Fame Super Silver

Re: Ethernet interface redundancy

Hello Niklas,

you can use IRB integrated routing and bridging: HSRP will not work as well explained by Jon.

bridge 1 protocol ieee

bridge 1 route ip

bridge 1 bridge ip

int eth0

no ip addr

bridge-group 1

int eth1

no ip addr

bridge-group 1

int bv1

ip address x.x.x.x

! this the layer3 interface

be aware that STP will block one link but it will be ready to be used if the first fails

you can uses static routes with IP next hops the ip addresses of the VIP of the HSRP made on the other two routers (on them you can they are two different boxes)

the other two routers will have static routes to the BVI ip address as next hop

be aware that until a router has an ARP entry for the ip next hop and its own interface is up the static route is considered valid

Hope to help

Giuseppe

118
Views
0
Helpful
3
Replies