Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ethernet module for 2851

Hi, There:

Is there any ethernet module for 2851, so I could build layer 3 ethernet channel, and setup 2 ip address on it?

Primary and secondary.

Thx

1 REPLY

Re: ethernet module for 2851

you can get NM-16ESW, it has 16 ethernetport and have an option to get 1-Gig port or 2 gig port uplink. You can channel the port in layer 2 and trunk it and create vlan, better than primary and secondary ip addresses but you can do primary and secondary on a vlan too.

310
Views
0
Helpful
1
Replies
CreatePlease to create content