Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ethernet Module for Cisco 2650

Hello

I'm envolved in a students-project at the university of mine. We want to build a closed network to improve our networking skills.

Therefore we bought for little money a cisco 2650 from a company. Our problem is, that there is only one ethernet port on that device. But we need two or more ethernet interfaces for each segment.

We now want to know, which of the huge number of modules and wic's is the right one for us.

Can somenone suggest us an useful and affordable module? Thanks in advance.

5 REPLIES
New Member

Re: Ethernet Module for Cisco 2650

Hi,

You can use cisco 1841 router, that one is having Two fastethernet port and this one is very cheap and best.

Thanks...Mukesh

Re: Ethernet Module for Cisco 2650

Hi friend,

check this link out for different ethernet modules available for a 2600 series

http://www.cisco.com/en/US/products/hw/routers/ps274/products_data_sheet09186a0080091b89.html

HTH, rate if it does

Narayan

Re: Ethernet Module for Cisco 2650

Hi there,

Rahter than spend money to get another ethernet interface, you could trunk the interface to a switch and have it as a router on a stick.

Using subinterfaces you can have all the ethernets you'll need. Check out this link for more details:-

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fswtch_r/xrfscmd1.htm#wp1056958

Hope that helps

LH

Please rate all posts

New Member

Re: Ethernet Module for Cisco 2650

Thans very much royalblues!!!

Sorry for the wrong rating, i wanted to rate the answer above!!! Your answer was really helpful and solved my issue.

Re: Ethernet Module for Cisco 2650

Glad to help.

It's worth noting that the trunking on a router is a feature and you will need a specific version of IOS to run it - not a very hight one, usually IP Plus. Have a look at the feature navigator to see if your IOS is supported - or just type in the commands on the router!!

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

Regards,

LH

Please rate all posts

319
Views
15
Helpful
5
Replies