Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ethernet Switch Module transmit queue is full

Please help!

1 REPLY
Cisco Employee

Ethernet Switch Module transmit queue is full

Hey,

The error message is indicating buffer overflow on the interfaces, which

is probably accompanied by the large amount of overruns on the interfaces. This

shows the number of times that the receiver hardware was incapable of

handing received data to a hardware buffer because the input rate exceeded the receiver's capability to handle the data.

This in turn caused the traffic to be SW switched and led to CPUHOG which triggered the crash.

SO there is too much traffic coming to this switch. I would suggest to offload some traffic to another interface from the one which get most of input errors/overruns if possible.

Hope this helps,

Nik

3210
Views
0
Helpful
1
Replies
CreatePlease login to create content