Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Ethernet to T1

I have a 1601R router with a serial connection to a Audit 600 which is connected to Westell T1 Factory Loopback unit A90-310027 (Audit and Westell owned and maintained by Phone Company). If I upgrade to a 1841 router do I need to purchase the WIC 1DSU card? Can I go straight into the Westell with an Ethernet cable?

1 REPLY
Purple

Re: Ethernet to T1

Hello,

You will have to get the WIC-1DSU in order to connect to your T1. You cannot, unfortunately, use any of the built-in ethernet ports for this purpose.

Hope that helps - pls rate the post if it does.

Regards,

Paresh

99
Views
0
Helpful
1
Replies
CreatePlease to create content