EtherSwitch Service Modules on router 2851

[sanyaolu]

How can i log on to the Switch module "NME-XD-48ES-2S-P" on Router 2851. I just installed the module and don't know how i can get into the switch part of the roter and configure it.

All the interfaces i can see on the router are

Router1#sho ip inter bri

Interface IP-Address OK? Method Status Protocol

GigabitEthernet0/0 10.2.2.2 YES NVRAM up up

GigabitEthernet0/1 10.1.1.1 YES NVRAM up up

GigabitEthernet1/0 x.35.178.141 YES NVRAM up up

Loopback0 x.35.178.135 YES NVRAM administratively down down

Adeolu

[JORGE RODRIGUEZ]

Read this link for initial configuration of switch service modules

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_feature_guide09186a0080415bae.html

Read Minimun IOS requirements (table-4)

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a00801aca3e.html