Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EtherSwitch Service Modules on router 2851

How can i log on to the Switch module "NME-XD-48ES-2S-P" on Router 2851. I just installed the module and don't know how i can get into the switch part of the roter and configure it.

All the interfaces i can see on the router are

Router1#sho ip inter bri

Interface IP-Address OK? Method Status Protocol

GigabitEthernet0/0 10.2.2.2 YES NVRAM up up

GigabitEthernet0/1 10.1.1.1 YES NVRAM up up

GigabitEthernet1/0 x.35.178.141 YES NVRAM up up

Loopback0 x.35.178.135 YES NVRAM administratively down down

Adeolu

1 REPLY

Re: EtherSwitch Service Modules on router 2851

317
Views
4
Helpful
1
Replies
CreatePlease to create content