Hi we have a 6509 running 12.2(17d)SXB11 with a strange error
A LES 100mb circuit is plugged into port gi4/48 L3 (copper) when utilisation of this hits 100% it causes extreme packet loss on ports gi1/48 and gi1/41 which are completely un-realted (one is another LES circuit 100mb copper L3 link and one is to a server in the same room 1000mb L2).
has anyone ever experienced anything like this before? I guess it could be a hardware fault but all reports and logs show no fault.
>> also why would performance on module 4 effect module 1?
I took the two ports as being on the same linecard !
Sorry for this, they should be unrelated but I see you are doing some form of circuit emulation what do you mean with LES ?
this can create a link between the ports the feature may allocate buffers or queues that are shared and when one link is full other frames wait to be transmitted filling these resources. (just a guess)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...