ā01-23-2010 05:26 AM - edited ā03-04-2019 07:16 AM
Factory defaults terminal problem
As I mentioned in previous post I made a factory default reset,
now I connect to my console,
with putty:
Serial type, speed 9600... Open
Now the black screen appears and I cant nothing write there... trying ctrl +c nothing helps..
please help
The problem is on CISCO 2800 ROUTER
Solved! Go to Solution.
ā01-23-2010 06:08 AM
slash281990 wrote:
would u like to enter initial configuration dialog ? yes/ no
what should i select?
I just wanna boot the web interface and so on.. and after that to configure
Select yes and then assign your 10.x.x.x address to one of the ethernet interfaces.
Jon
ā01-23-2010 06:09 AM
thx
P.S and one more question... please say me how to set the default gateway on the router through wich the inet is comming? the command please
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: