I'm doing a practice from the "CCNA Exploration 4.0: Accessing the WAN Student Packet Tracer Manual" (PT Activity 2.1.7: Troubleshooting a Serial Interface). I made the topology according to the image and set the IP addresses on the correct interfaces. Almost, I put the serial cable (Router2 to Router3) in the correct serial port (0/0/1 - 0/0/1).
By default, Packet Tracer sets all the routers with HDLC encapsulation.
When I try to make a ping from PC1 to PC3, I can't. I checked all my topology and I don't found the problem.
I attached and imagen and my .pkt project.
Sorry for my bad english, the project name, and the question, but I'm new using this discussion forum. Thank you for all.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...