Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

failover between Cisco routers

Dear Experts,

I have 2 Cisco routers 3945. Use HSRP for links failover.

Does exist any possibility (any protocol) which makes routers configuration's automatic synchronization (as failover for ASA firewalls)?

I mean, if I will make any configuration changes on the Active router, automticly will taken this changes by the Standby router.

Mamuka

3 REPLIES
Purple

failover between Cisco routers

Hi,

as far as I know it's impossible to do that, the only sync you could do is for the NAT translations using SNAT which is deprecated now.

Regards.

Alain

Don't forget to rate helpful posts.
Silver

failover between Cisco routers

Not possible.Would it have been like 6500 with dual sup running redundant mode,in that case yes auto sync config options are there .same for ASAs but not in case of routers.in SNAT also the translation table will be copied.

---

Posted by WebUser Mukti Chandwani

New Member

failover between Cisco routers

OK. Thank you for information.

Mamuka

266
Views
0
Helpful
3
Replies
CreatePlease to create content