I would like to configure a 1720 12.1(27b) with failover between two WIC's. I've been searching for a document that might describe some scenarios but I haven't found any. Please point me in the right direction. Thanks
Your routing protocol will take care of failover for WAN connections. You need to document your network and select the routing protocol that fits your design. If your WICS terminate at the same place, use either two static routes or enable a routing protocol.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...