Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Failover

Dear all,

I have a cisco router 2811 connect to internet (s0/0 is connect to wan). This router have two faEthernet ports (fa0/1:192.168.50.1,fa0/2:192.168.51.1)

fa0/1 is connect to a switch 1 (3750)(192.168.50.2) and fa0/2 is connect to a switch 2 (3750)(192.168.51.2), switch1 and switch 2 are set to HRSP.

switch 1 is master. but I found that the traffic through switch2 to my internal network, but I want the traffic through switch 1 to my internal network when the switch 1 is ative

How can I set  the router or switch ?

thank you

1 REPLY
Cisco Employee

Re: Failover

Hi Lam Lam,

Is there a link between sw 1 and sw 2? Is it L2 or L3? Does spanning tree root bridge match the HSRP primary, in your case on sw1?

Regards,

Lei Tian

169
Views
0
Helpful
1
Replies
CreatePlease to create content