Unfortunatly I am very limited in my knowledge of routers. Our network person position was terminated recently and I am handling the problems so please bear with me if my terminology is incorrect. I have a 2650 that received its configuration from a TFTP server however the FE0/0 has the following configuration: ip address 10.10.10.1 255.255.255.0, ip nat inside, shutdown duplex auto and speed auto. When I compare this to the configuration that is on the TFTP there is no "Shutdown" within it. How do I go about removing this from its running config? Can this be done remotely. The router is in Alaska and I am in New Jersey. Thanks in advance for your help.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.