Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

First time user of a 2821 using VWIC-2MFT-T1 for data

I am switching over from 2600 serier to a new 2821 so that I may have 4 T1's data only (no voice). On the old 2600 a T1 was configured as such:

interface Serial0/0

description Wherever

ip address 10.201.254.1 255.255.255.0

no ip directed-broadcast

no ip mroute-cache

no fair-queue

service-module t1 timeslots 1-24

!

What would have to be configured on the new VWIC-2MFT-T1 to get the equivelent?

I see 4 controllers.

Could someone give me an example of how this would be done?

2 REPLIES
Silver

Re: First time user of a 2821 using VWIC-2MFT-T1 for data

To use the VWIC card, configure the controller to create the serial interface

controller T1 0/0

channel-group 0 timeslots 1-24

(Note that other T1 specific config might be necessary for the T1 to come up).

This create a serial interface, s0/0:0, which you can now assign an ip address.

interface Serial0/0:0

ip address 10.201.254.1 255.255.255.0

New Member

Re: First time user of a 2821 using VWIC-2MFT-T1 for data

Thank you!!! You simple example limited my focus down and I finally understood the syntax. My ending result was:

controller T1 0/0/0

framing esf

linecode b8zs

channel-group 0 timeslots 24

description whatever

interface Serial0/0/0:0

description whatever

ip address 10.201.254.1 255.255.255.0

Following the documentation was showing the wrong number of 0 and / 's ...

Thanks a bunch

206
Views
0
Helpful
2
Replies
CreatePlease login to create content