Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

flapping between port

Has anyone seening the below message before

%SW_MATM-4-MACFLAP_NOTIF: Host 0007.b32c.f18a in vlan 30 is flapping between port Gi0/1 and port Gi0/2

2 REPLIES
Bronze

Re: flapping between port

I see this error pretty consistently, as we run bonded interfaces on all of our servers. We used to have quite a few of these messages and it turned out to be related to the bonding settings and how the bonded interfaces detected who was active and who was standby. We've managed to reduce the number by double checking those settings and making sure things are setup correctly for our environment. I still see these messages on some of our Linux based servers that don't have bonds setup correctly.

Hall of Fame Super Bronze
273
Views
0
Helpful
2
Replies