Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

flapping interface wic-2t on a 2800 router

Hello,

I am a cisco academy student and I am attending courses within the Dallas Fort Worth area.  I wish to know how I can identify why the interfaces in our lab are flapping.  I have discussed this with my professor and he mentioned that this is a known issue with the newer interfaces that they purchased and that sometimes there is irregular flapping on wic-2t interfaces within the lab.  I am sure that he is taking steps to isolate and troubelshoot the problem but I was wondering what are the most useful debug commands, best practices I could use to see why an interface is flapping.  So long as an interface is configured properly with the right IP address, mask, clocking if needed, then it should not flap, but if it does other than swapping out wic cards and replacing cables (which I already did with my professor) if the interface continues to flap how can I troubleshoot?

Sometimes with these troubled interfaces the line protocol will never come up.  In that case is there any reccomended way to troubleshoot these issues.

Thank you in advance!

Joshua

2 REPLIES
Hall of Fame Super Gold

Re: flapping interface wic-2t on a 2800 router

If it is a fault in the product (and it can be), there is nothing you can do about.

Just use something else for your studies.

Re: flapping interface wic-2t on a 2800 router

IMHO,

Raise a TAC and if the card is faulty let it be replaced.

Regards

341
Views
0
Helpful
2
Replies