Re: flash files creation dates changed after daylight savings ti
I do not know the answer authoritatively. So this is my understanding not necessarily a fact. I believe that time and time and date stamps are really recorded in UTC (Coordinated Universal Time or GMT) and are translated into local time by show commands, the syslog process etc. So the time and date recorded for the file in flash were rendered as one time when we were on daylight savings time and are rendered one hour earlier when we move into standard time. They both are based on the same underlying UTC.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...