Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Flash issues

Hi,

I have a 2611XM 32F, router that I want to upgrade the Flash to its max capacity of 48MB.

http://www.cisco.com/en/US/docs/routers/access/2600/hardware/installation/notes/2600mem.html

The above document states the Flash increments of 16, 32, and 48MBs with a 3.3-V simm for my model. It also lists the part numbers for a 16MB and 32MB simm, omitting the 48MB.

I found the following term "16MB Non removable base memory" from:

http://www.memoryx.net/ci26moacrofm3.html

I just can't find any official clarification on cisco.com, re if theres 16MB onboard (nonremovable), and whether an upgrade to 48MB, just requires a 32MB chip. I currently do not have physical access to the deivce. I can't find the link I had yesterday, but I'm pretty sure there is only 1 simm slot on the board.

Any help would be much appreciated, thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Flash issues

Yes the XM always have 16MB soldered on MB and yes upgrade to 48 MB requires a 32 MB module.

Please rate post if it helps!

2 REPLIES
Hall of Fame Super Gold

Re: Flash issues

Yes the XM always have 16MB soldered on MB and yes upgrade to 48 MB requires a 32 MB module.

Please rate post if it helps!

New Member

Re: Flash issues

Thanks a million!

232
Views
0
Helpful
2
Replies