Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

flow control on gigabitethernet router cisco 2911

Good morning,

I've a problem with a router 2911 (IOS 151-2.T1.bin).

On gigabitethernet 0/0 with  command sh interface.... is see  this line

output flow-control is XON, input flow-control is XON

On the other gigabitethernet  with the same command  I see

output flow-control is unsupported, input flow-control is unsupported

How it's possible to modifiy  the gigabitethernet to have   output flow-control is unsupported, input flow-control is unsupported?

Thanks in advance

regards

giancarlo

1 ACCEPTED SOLUTION

Accepted Solutions

flow control on gigabitethernet router cisco 2911

Try this one:

https://supportforums.cisco.com/thread/2027655

Michael

Please rate all helpful posts

Michael Please rate all helpful posts
1 REPLY

flow control on gigabitethernet router cisco 2911

Try this one:

https://supportforums.cisco.com/thread/2027655

Michael

Please rate all helpful posts

Michael Please rate all helpful posts
3284
Views
0
Helpful
1
Replies
CreatePlease to create content