Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

fractional T3

Hi, I am going to setup a new point to point internet link that is fiber. It is a fractional T3 (4.5Mbps) Is there anything that I have to setup for on this interface? I know that when setting up a fractional T1 you have to specify service time slots. Also do I have to specify the bandwidth of the connection? Thanks

1 REPLY

Re: fractional T3

On T3's my experience is that the "dsu-bandwidth" must match at both ends. I believe you can have a channelized T3 but I think it's unusual, especially for Internet.

Paul

230
Views
0
Helpful
1
Replies