My question is about interface and sub-interface configuration for frame relay. In my studies and simulations I have learned that one can use point to point subinterfaces, a physical interface configured with inverse arp, or static mapping with the frame-relay map command. Can multiple frame-relay map commands be used on one interface to configure paths to multiple dlcis?
multiple map commands can be configure on fram relay multipoint interfaces.In case of point to point no mapping is required.
A ?multipoint? interface by definition is an interface that may connect to multiple end points of a network. Both physical interfaces and multipoint subinterfaces in Frame-Relay are by definition ?multipoint?.
Yes you can have multiple FR map statements on a multipoint interface. For some good examples regarding frame relay configuration have a look at the Cisco IOS Wide-Area Networking Configuration Guide, Release 12.4, Chapter "Configuring Frame Relay" at
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...