Frame-relay MPLS works on VIC-MFT but not on WIC-1DSU
I have a facility that has WAN connectivity problems. I have an AT&T Frame-relay MPLS WAN. If I have the circuit connected to the router via a WIC-1DSU-T1-V2 the circuit will not come up. If I connect the same circuit to the same router via a VIC-1MFT-T1 the circuit will come up. Any ideas? This just all of a sudden happened. We had the circuit connect via the 1DSU for many months without problems. AT&T is saying that everything is fine on their end.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...