I have two routers (2610XM and 2621XM) connected to each other via V.35 DCE/DTE, and I'm trying to configure a Frame Relay connection over this (along with two other routers, but first things first). However, I can't keep the link up. The DCE end is configured with a clock rate of 128000, but the DTE end only says "DTE V.35 TX and RX clocks detected." The interfaces on both ends are up/down; the subinterfaces (on which the DLCIs and IPs are configured) are down/down on both ends. Neither router has its directly connected subnet in its routing table.
I can bounce the interface on either end, and the link comes up for a few seconds, during which time both routers recognize the directly connected subnet that connects them. However, the DTE end still has only the TX/RX clocks detected message. And the link goes back down after a few seconds.
During the time the link is up, also, no LMI messages appear to be getting received on either end even though plenty are being sent. Two obvious things of keepalives and frame relay encapsulation are configured on the interfaces of both ends.
Does the clocks detected message mean that I have a good back-to-back cable setup? If not, how do I finish that setup?
If the cable setup is good, at what else should I be looking in order to get the link to stay up so I can work the Frame Relay config?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.