cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
288
Views
0
Helpful
1
Replies

frame-relay payload-compression

lgontarsk
Level 1
Level 1

Hi, does anyone know the difference between the packet-by-packet vs frf9stac parameters for this command?

Thanks,

Lisa G

1 Accepted Solution

Accepted Solutions

aghaznavi
Level 5
Level 5

1.Payload compression on each VC consumes approximately 40 kilobytes for dictionary memory.

2.FRF.9 compression uses relatively higher compression ratios, allowing more data to be compressed for faster transmission. FRF.9 compression provides the ability to maintain multiple decompression/compression histories on a per-DLCI basis.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080fdc.html#wp1066773

View solution in original post

1 Reply 1

aghaznavi
Level 5
Level 5

1.Payload compression on each VC consumes approximately 40 kilobytes for dictionary memory.

2.FRF.9 compression uses relatively higher compression ratios, allowing more data to be compressed for faster transmission. FRF.9 compression provides the ability to maintain multiple decompression/compression histories on a per-DLCI basis.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080fdc.html#wp1066773

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: