Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

frame-relay payload-compression

Hi, does anyone know the difference between the packet-by-packet vs frf9stac parameters for this command?

Thanks,

Lisa G

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: frame-relay payload-compression

1.Payload compression on each VC consumes approximately 40 kilobytes for dictionary memory.

2.FRF.9 compression uses relatively higher compression ratios, allowing more data to be compressed for faster transmission. FRF.9 compression provides the ability to maintain multiple decompression/compression histories on a per-DLCI basis.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080fdc.html#wp1066773

1 REPLY
Silver

Re: frame-relay payload-compression

1.Payload compression on each VC consumes approximately 40 kilobytes for dictionary memory.

2.FRF.9 compression uses relatively higher compression ratios, allowing more data to be compressed for faster transmission. FRF.9 compression provides the ability to maintain multiple decompression/compression histories on a per-DLCI basis.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080fdc.html#wp1066773

99
Views
0
Helpful
1
Replies
CreatePlease to create content