Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame relay point to point config-help needed

Hello all,

I need pointer to a link (I have already check cisco frame relay config documents on CCO) or document which will be able to provide info on how to configure frame relay point to point subinterfaces on R1, R2 and R3 where all three routers are connected to FR switch. Except for R1 which has two WAN links connected with FR switch, rest of the routers have only 1 WAN link.

I will be using OSPF for routing.

Thanks in advance

2 REPLIES
New Member

Re: Frame relay point to point config-help needed

Hi , I read your posting and yu can configure FR point to point sub-interfaces off of your serial interface. Yu can then assigned the DLCI and other information on the link, the document link below should have all the information you need to complete the task.HTH

http://www.cisco.com/en/US/docs/ios/wan/configuration/guide/wan_cfg_frm_rly_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1003569

Silver

Re: Frame relay point to point config-help needed

99
Views
0
Helpful
2
Replies