I have a home lab setup with 3 routers connected to a 2520 router configured for frame relay. When I set up the hub and spoke using point-to-point I can ping the spoke routers from R1. My problem is when I try to set up the lab using multipoint. The ping just immediately comes back with % Unrecognized host or address, or protocol not running.
I set up the frame map to ping the other two routers but it still doesn't work. Everything shows active:
R1>show frame map Serial3/0 (up): ip 220.127.116.11 dlci 122(0x7A,0x1CA0), static, broadcast, CISCO, status defined, active Serial3/0 (up): ip 18.104.22.168 dlci 123(0x7B,0x1CB0), static, broadcast, CISCO, status defined, active
R1>show frame lmi
LMI Statistics for interface Serial3/0 (Frame Relay DTE) LMI TYPE = CISCO Invalid Unnumbered info 0 Invalid Prot Disc 0 Invalid dummy Call Ref 0 Invalid Msg Type 0 Invalid Status Message 0 Invalid Lock Shift 0 Invalid Information ID 0 Invalid Report IE Len 0 Invalid Report Request 0 Invalid Keep IE Len 0 Num Status Enq. Sent 711 Num Status msgs Rcvd 712 Num Update Status Rcvd 0 Num Status Timeouts 0 Last Full Status Req 00:00:34 Last Full Status Rcvd 00:00:34
Thank you both for the quick reply. Sometimes it is the obvious. After I did the write erase on all the routers I forgot to configure the interfaces. I need to study earlier in the day. Again, thank you for the help.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.