Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame-relay PVC

Hi just had a quick question for you to disable a PVC all I have to do is disable the sub interface that is was created on? So if I have a pvc s0/1/0.22 and the PVC is 22 and I wanted to disable the PVC 22 all I would have to do is:

config t

inter s0/1/0.22

shut

???

Thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Frame-relay PVC

Hi,

Just do a shut on the normal interface

inter s0/1/0

shut

That will disable the PVC of all interfaces regarding that interface/subinterfaces.

If you only want to disable the PVC of dome subinterface just shut the subinterface.

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################

1 REPLY

Re: Frame-relay PVC

Hi,

Just do a shut on the normal interface

inter s0/1/0

shut

That will disable the PVC of all interfaces regarding that interface/subinterfaces.

If you only want to disable the PVC of dome subinterface just shut the subinterface.

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################

112
Views
5
Helpful
1
Replies
CreatePlease login to create content