Frame-relay QOS with Policy-Map - Strange BW breakdown
I recently applied the following policy and class maps and are seeing some strange results on a 1.536Mb circuit: Here the bandwidth used by the default class is nearly the same as the BW going across the seperate PVCs. But all the PVCs are setup in the class-maps so there should be nothing in the default class... Has anyone come across this before?
sh policy-map int se 1/0 | i Class-map|rate
Class-map: voice (match-any)
30 second offered rate 41000 bps, drop rate 0 bps
30 second rate 41000 bps
Class-map: voice-control (match-any)
30 second offered rate 0 bps, drop rate 0 bps
30 second rate 0 bps
Class-map: 1_0_101 (match-any)
30 second offered rate 248000 bps, drop rate 0 bps
30 second rate 248000 bps
Class-map: 1_0_102 (match-any)
30 second offered rate 7000 bps, drop rate 0 bps
30 second rate 7000 bps
Class-map: 1_0_106 (match-any)
30 second offered rate 100000 bps, drop rate 0 bps
30 second rate 100000 bps
Class-map: class-default (match-any)
30 second offered rate 347000 bps, drop rate 0 bps
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...