Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame Relay - RV016

Dears, I would like to know if I can configure the router linksy - Cisco to receive a Frame Relay link?

The protocol is sent pel PPP provider as part of a configuration below, which I received from the provider.

Protocol MLPPP / Routing / Static Routing Balancing NO / Address Block (LAN) 192.168.4.0 / Address Mask 255.255.255.0 / Topology Full MeshedQoS NO.

1 REPLY
Hall of Fame Super Silver

Re: Frame Relay - RV016

Hello Mauricio,

after reading the service provider specifications I would say you should configure your device with encapsulation PPP or multilink PPP rather then frame relay.

It is possible to run PPP over Frame Relay but I don't know if this is your case.

Hope to help

Giuseppe

240
Views
0
Helpful
1
Replies
CreatePlease to create content