cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
226
Views
0
Helpful
1
Replies

Frame-Relay Switching Again?

newnetman
Level 1
Level 1

Hello All,

I am receiving the following error message on a router intended for the frame-relay switching. Even though the router has been configured as a FRAME RELAY SWITCHING. Though i did not configure any IP on the interface as i don't need one to the best of my knowledge or am i wrong? or where am i missing something out? please help me.

HERE IS THE ERROR MESSAGE ( the cable side is DCE already)

"Router(config-if)#clock rate 56000

%Error: This command applies only to DCE interfaces

Router(config-if)#

1 Reply 1

Edison Ortiz
Hall of Fame
Hall of Fame

show controller serial x/x | i DTE|DCE

should tell you if the interface is acting as DCE or DTE.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: