Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame-Relay Switching Again?

Hello All,

I am receiving the following error message on a router intended for the frame-relay switching. Even though the router has been configured as a FRAME RELAY SWITCHING. Though i did not configure any IP on the interface as i don't need one to the best of my knowledge or am i wrong? or where am i missing something out? please help me.

HERE IS THE ERROR MESSAGE ( the cable side is DCE already)

"Router(config-if)#clock rate 56000

%Error: This command applies only to DCE interfaces

Router(config-if)#

1 REPLY
Hall of Fame Super Bronze

Re: Frame-Relay Switching Again?

show controller serial x/x | i DTE|DCE

should tell you if the interface is acting as DCE or DTE.

111
Views
0
Helpful
1
Replies