I'm trying to setup frame-relay switching. I was having trouble with the connection. I have 2 2691 and 1 2621 router. I set up 1 2691 as the Frame-Relay swith and to other 2 as remote devices. I was practicing the multi-point frame relay. I was able to make the 2 2691 routers communicate but not able to make the 2621 communicate with the remote device. see logs below:
I think I already checked everthing but the connection from 2691 to 2621 doesn't seems to work. I already tried interchaning the router connection but the 2621 is always the one that does not work. Please assist. Thanks in advance.
Fr-Sw#sh frame-relay route
Input Intf Input Dlci Output Intf Output Dlci Status
Serial0/0 111 Serial0/1 222 inactive
Serial0/1 222 Serial0/0 111 active
Serial0/1 is up, line protocol is down
Hardware is GT96K Serial
MTU 1500 bytes, BW 1544 Kbit/sec, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation FRAME-RELAY, loopback not set
Keepalive set (10 sec)
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0
LMI enq recvd 106, LMI stat sent 106, LMI upd sent 0, DCE LMI down
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.