02-26-2007 06:22 AM - edited 03-03-2019 03:56 PM
I have 2 t1 CSU/DSU WIC card in cisco2800 and cisco2651 XM. This is my fisrt time doing this. Can you please specify which cable exactly I shd use:
Frame-relay switching is enbaled on both routers globally...
below is my config
interface Serial0/0
description FR switch
no ip address
encapsulation frame-relay
no keepalive
no fair-queue
frame-relay interface-dlci 201
!
interface Serial0/0.21 point-to-point
ip address 131.1.12.2 255.255.255.0
frame-relay interface-dlci 201
interface Serial0/3/0
description FR switch
no ip address
encapsulation frame-relay
no keepalive
frame-relay lmi-type cisco
frame-relay intf-type dce
!
interface Serial0/3/0.12 point-to-point
ip address 131.1.1.1 255.255.255.0
frame-relay interface-dlci 101
02-26-2007 06:52 AM
Configuring frame relay:
http://www.cisco.com/en/US/tech/tk713/tk237/tech_configuration_examples_list.html
02-26-2007 07:22 AM
Thanks for your help.
The interface is still down. I am using a xover cable between both router and it is till not working....
02-26-2007 07:54 AM
Which csu/dsu are you using? Did you configure the controller correctly?
I suggest you tray to get the T1 link working first and then change encapsulation to FR.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: